Setting the clock, Adjusting brightness of the display, Volume control – Yamaha EMX100RDS User Manual
Page 21: E-13 english, Volume control setting the clock
E-13
English
If desired, you can adjust brightness of the display.
1
Press and hold the DISPLAY button for more than 2
seconds so that “DIMMER±0” appears on the display.
2
Holding the DISPLAY button pressed, turn the VOLUME
control clockwise to increase or counterclockwise to
decrease brightness.
This adjustment can be made even though this unit is in the
standby mode.
Control range
When the power is on: ±0 to –6 (Preset value: ±0)
When this unit is in the standby mode : +3 to –3 (Preset
value: ±0)
ADJUSTING BRIGHTNESS OF THE DISPLAY
Front panel operation
Rotate the VOLUME control clockwise to increase the
volume, and counterclockwise to decrease the volume.
Remote control operation
Press the VOLUME + button to increase the volume and the
VOLUME – button to decrease the volume.
* Adjusted volume level is shown by the volume level meter
and in figures on the display.
VOLUME CONTROL
SETTING THE CLOCK
1
While the power is on, press the DISPLAY button to
display the time. If this unit is in the standby mode, you
can proceed to the next step.
2
While holding the TIME ADJ button pressed, press the
HOUR button and set the hour.
*
Press the HOUR button once to advance the time by 1
hour. Press and hold to advance continuously.
3
While holding the TIME ADJ button pressed, press the
MIN button and set the minute.
*
Press the MIN button once to advance the time by 1
minute. Press and hold to advance continuously.
In the event of a power failure or when the AC supply
lead is disconnected.
The time display will go out, however, the clock will function
for about 5 minutes without power supply. So you do not
have to reset the time if the AC power supply is resumed
within about 5 minutes.
When the AC power supply is resumed after more than 5
minutes pass without power supply, the time display will flash
on and off to indicate that the time must be reset.
REPEAT
TIME
MEMORY
HOUR
MIN
TIME ADJ
DISPLAY
REPEAT
TIME
MEMORY
HOUR
MIN
TIME ADJ
1
2
3
Changes.
Changes.
MODE PTY SEEK START
MODE PTY SEEK START
VOLUME
VOLUME
VOLUME