Wachsmuth & Krogmann KingKraft ZJ4116QA - Manual (Page 7)

z Wait for tool bit to stop spinning.
z Unplug the drill press.
z Make workshop child-proof. Lock the shop. Disconnect master switches. Remove the
yellow switch key. Store it away from children and others not qualified to use the
tool.
Electrical Requirements
General Electrical Connections
DANGER: To reduce the risk of electrocution:
1. Use only identical replacement parts when servicing. Servicing should be
performed by a qualified service technician.
2. Do not use in rain or where floor is wet.
This tool is intended for indoor residential use only.
WARNING: Do not permit fingers to touch the terminals of plug when installing
or removing the plug to or from the outlet.
Grounding Instructions
110-120 Volt, 60Hz. Tool Information
NOTE: The plug supplied on your tool may not fit into the outlet you are planning to
use. Your local electrical code may require slightly different power cord plug connections.
If these differences exist refer to and make the proper adjustments per your local code
before your tool is plugged in and turned on.
In the event of a malfunction or breakdown, grounding provides a path of least
resistance for electric current to reduce the risk of electric shock. This tool is equipped
with an electric cord having an equipment grounding conductor and a grounding plug, as
shown. The plug must be plugged into a matching outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
Do not modify the plug provided. If it will not fit the outlet, have the proper outlet
installed by a qualified electrician.
A temporary adapter may not be used with this item.
WARNING: If not properly grounded, this tool can cause an electrical shock,
particularly when used in damp locations, in proximity to plumbing, or out of
doors. If an electrical shock occurs there is the potential of a secondary hazard,
such as your hands hitting the cutting tool.
Wire Sizes
6