weber 3400 Series - Manual (Page 33)

33 33
F
E
F
E
Figure 8
Male fitting
Regulator
Collar
Quick disconnect
engaged
Figure 7
(a)
(b)
c) Connect the hose to the tank. Slide back the collar of
the quick disconnect on the tank valve. Figure 7 (a).
Push the male fitting of the regulator into the quick
disconnect, and maintain pressure. Slide the collar
closed. Figure 7 (b). If it does not engage or lock,
repeat procedure. Gas will not flow unless the quick
disconnect is properly engaged.
d) Mix soap and water.
e) Open the tank valve. Figure 8.
f) Check for leaks by wetting the fitting with the soap and
water solution and watching for bubbles. If bubbles
form or if a bubble grows there is a leak.
If leak does not stop, turn off the gas and contact
Weber-Stephen Customer Service. Do not use
the barbecue.
g) When leak checks are complete, turn gas supply OFF
and rinse connections with water.
LP Tank
The LP tank manufacturer is responsible for the materials,
workmanship and performance of the tank. If the tank has a
defect, malfunctions, or you have a question regarding the
tank, call the tank manufacturer's customer service center.
The phone number is on the warning decal which is
permanently attached to the tank. If the tank manufacturer
has not resolved the issue to your satisfaction, then call
Weber-Stephen Products Co., Customer Service Center.