weber 3400 Series - Manual (Page 18)

18
Figure 20
Figure 19
View from front left View from front right
F
E
F
E
Igniter
lock nut
Keyhole in
frame brace
Small part of
keyhole in
frame brace Frame brace
(b) (a)
(a)
(b)
(c)
Step 17
Install bottom accessory trays
You will need: two accessory trays
Set the two accessory trays between the two frame
connectors. Figure 19.
Step 16
Add fuel scale
You will need: fuel scale assembly, two 1/4-20 wing nuts
and two nylon washers.
Insert indicator rod of fuel scale through the elongated
hole in the right end panel. Figure 18 (a).
Slip the bolts on the back of the fuel scale assembly through
the two small holes in the right end panel and tank panel.
Add washers, then wing nuts and tighten. Figure 18 (b).
Step 18
Install igniter
Note - The igniter wires are already attached to the Gas
Catcher Ignition Chamber and the igniter. This was done
to factory test the ignition system.
The igniter lock nut is on the igniter.
Route the igniter and wires as shown. Figure 20 (a). Insert
the top of the igniter up through the large part of the keyhole
in the frame brace. Figure 20 (b). Loosen the igniter lock nut
and slide the igniter to the rear of the keyhole. Figure 20 (c).
Tighten the igniter lock nut.
Note - If the igniter works loose, carefully tighten the
igniter lock nut with an adjustable wrench or pliers.
Figure 18