Wells WM-TR - Manual (Page 7)

UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all
protective plastic film, packing materials and accessories from
the
Appliance before connecting electrical power or otherwise
performing any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the appliance before starting any
installation.
Read all instructions in this manual carefully before starting in-
stallation of this dispenser. READ AND UNDERSTAND ALL
LABELS AND DIAGRAMS ATTACHED TO THE DISPENSER.
Carefully account for all components and accessories before dis-
carding packing materials.
1 ea. WATER-MAX™ DISPENSER
1 ea. AIR OUTLET GUARD
4 ea. ADJUSTABLE LEGS
1 ea. WATER TANK ASSEMBLY with LID
1 ea. DELIMING SOLUTION BOTTLE
1 ea. LITERATURE PACKAGE
Store these components in a convenient place for later use:
SETUP
Verify that this dispenser installation is in compliance with the
specifications listed in this manual and with local code requirements.
THIS IS THE RESPONSIBILITY OF THE INSTALLER.
Recommended height of the faucet is 38” to 42”. However, the actual
installed height will vary with the requirements of the individual store.
For countertop installation:
The counter at the installation location must be level, provide a
clear space at least 17-1/2”” deep and must be structurally capable
of safely supporting the 150 pound weight of the fully operational
Water-Max™.
Set Water-Max™ on its back. Install the AIR OUTLET GUARD.
Guard is positioned on the bottom of Water-Max™, fully to the rear,
with the open portion toward the front. Install the REAR LEGS to
hold the guard in place.
Install the FRONT LEGS. Make certain all four legs have the
RUBBER FEET installed. Set Water-Max™ upright on the counter.
With the dispenser in its final installed location, adjust for level with
the adjustable legs. With a spirit level, check and adjust the
dispenser for level front-to-rear and side-to-side.
For wall mount installations contact your Authorized Wells Service
Agency:
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
WARNING:
Risk of
personal injury
Installation procedures must
be performed by a qualified
technician with full knowledge
of all applicable electrical and
plumbing codes. Failure can
result in personal injury and
property damage.
IMPORTANT: A one gallon
pitcher of water will weigh
about 8-1/2 pounds and will be
VERY HOT.
IMPORTANT:
Wall-Mount Installations —
Only factory- produced wall
mounting brackets are
authorized for use with Water-
Max™.
Use of any mounting means or
method other than the
factory-produced bracket voids
all warranty on this appliance.
Additionally, owner and/or
installer assume all liability in
connection with injury or
damage resulting from use of
any mounting means or
method other than the
appropriate factory-produced
bracket.
INSTALLATION
5