Wells H-636 - Manual (Page 9)

7
TROUBLESHOOTING
SYMPTOM
Hotplate won’t heat
One or more sections
won’t heat
Hotplate not hot enough
POSSIBLE CAUSE
Disconnect OFF or circuit breaker
tripped
Temperature control not on
Damaged temperature control,
element or other internal component
Temperature control not set
Operating 208/240V unit at 120V
Damaged temperature control,
element or other internal component
SUGGESTED REMEDY
Turn disconnect ON
Check / reset circuit breaker
Turn temperature control to
desired setting
Contact Authorized Wells
Service Agency for repairs
Adjust for desired temperature
Be sure supply voltage
matches nameplate voltage
Contact Authorized Wells
Service Agency for repairs
NOTE: There are no user
serviceable components in this
appliance. In all cases of
damage or component
malfunction, contact your
Authorized Wells Service
Agency for repairs.