VOX Amplification USA AC15C1 User Manual
Page 11
11
3. EFFECTS LOOP jack (AC30C2(X) only)
The EFFECTS LOOP allows effects to be added further down the signal chain,
rather than just plugging them in line with your guitar and amplifier. By using the
Effects loop with Delay stomp boxes, for example, will prevent any strange distor-
tions to the time delayed repetitions.
Please note that the EFFECTS LOOP sends at -10dB meaning it is suitable for
stomp boxes.
BYPASS ON/OFF: This is a true bypass effects loop which means if this is set in the
“BYPASS” position, absolutely none of your original signal will be running through
until it’s switched “ON”.
RETURN: Think of this as the “input” of the effects loop and will be connected to
the output of your effect(s).
NOTE! Be sure to use shielded guitar cables only! NEVER use unshielded speaker
cables.
SEND: Think of this as the “output” of the FX loop and will be connected to the
input of your effect(s).
4. FOOT SWITCH jack
This is where you connect the Optional VFS2A Foot Switch so you can turn the
REVERB and TREMOLO on and off.
5. MAINS INPUT connector
This is where the supplied, detachable Mains (power) cord is connected. The
specific mains input voltage rating that your amplifier needs to run at is located on
the rear panel of your amplifier. Before making any connections or powering up
the amplifier, make sure the correct voltage is set. If you have any doubt, refer to
your local VOX dealer.