VDO Dayton CD 2327 G - Manual (Page 20)

20
Interrupting TA
If you do not wish to continue listening to a par-
ticular Traffic Announcement broadcast, you can
interrupt it without switching off the TA mode.
Short-press the
AF
TA
button once, the hea-
dunit will return to the previous operating
mode.
Enhanced other Network (EON)
EON information allows the updating of RDS
information for programme services other than
the currently tuned station. By default, this EON
function is enabled. To toggle the settings:
Navigate the SAM to select ‘TA EON’.
Turn the knob clockwise / anti-clockwise to
toggle the modes (Off, Local or Distant).
Note: The reception of distant stations, which
may be weaker due to its distance, may be bad
and the audio output may be distorted as a re-
sult.
Programme Type (PTY)
This function is available with FM only. It enables
you to select stations by programme type. There
is a coding of up to 28 pre-defined programme
types – e.g. (in Europe): PTY1 News, PTY6
Drama, PTY11 Rock music.
Searching for a Programme Type
Long-press BAND
PTY
button to activate the PTY
function.
Short-press either button or button to
select the desired programme type.
Short-press either button or button
to search for PTY stations.
PTY Activation / De-activation
To change the operation mode of the PTY, you
need to change the setting in the SAM.
Navigate the SAM to select ‘PTY’.
Turn the knob clockwise / anti-clockwise to
toggle the PTY setting.
Note: Setting ‘PTY’ menu item to ‘NEWS INT’
will allow PTY-NEWS to interrupt (in a similar
way as TA interruption) when there is an incom-
ing NEWS.
RDS Regionalization
To change the way this headunit reacts to the
environmental conditions affecting the quality of
the radio stations, you can change the setting in
the SAM.
Navigate the SAM to select ‘REG-RDS’.
Turn the knob clockwise / anti-clockwise to
toggle the REG-RDS setting.
1.
1.
2.
1.
2.
3.
1.
2.
1.
2.
CD OPERATION
Loading CD into the Headunit
If not already on, short-press the
PWR
MUTE
button
to turn on the headunit.
Press the
REL button to flip down the front.
Insert the CD (label facing up) into the CD
slot.
Close the front.
The display should show “CD READ” while
still reading the disc.
When a disc is loaded, it will start playing auto-
matically.
Note: If a CD does not automatically load, DO
NOT FORCE it into the slot. This could damage
the CD and the headunit.
Ejecting a CD
Press the REL button to flip down the front.
Press the EJECT button to eject the disc.
Remove the disc.
Close the front.
Playing a CD-R or CD-RW
Depending on the type of CD-R / CD-RW CD,
surface condition of the disc, as well as the per-
formance and condition of the CD writer, certain
CD-R / CD-RW CD may not operate normally on
this headunit.
Playing a “Copy-Protected” non-
conforming audio CD
Due to the use of copy protection schemes of
some audio CDs, which are non-conforming to
international audio CDs standards (Red Book),
these types of copy-protected disc(s) may not
play on this headunit.
In the case of multi-session disc with such
schemes, you may try to disable the multi-ses-
sion ability by changing the SAM setting to allow
reading of at least the first session.
Navigate the SAM to select ‘MULTI-S’.
Turn the knob clockwise / anti-clockwise to
toggle the multi-session support.
Try playing the “copy-protected” disc again.
Note: Remember to enable the multi-session
support again in the SAM after playing this disc!
1.
2.
3.
4.
5.
1.
2.
3.
4.
1.
2.