Radio Shack PRO-72 - Manual (Page 50)

50
RESETTING/INITIALIZING THE
SCANNER
If the scanner’s display locks up or does not work properly
after you connect a power source, you might need to reset
or initialize it.
Important: If you have problems, first try to reset the
scanner. If that does not work, you can initialize the scan-
ner; however, initializing clears all frequencies you stored
in the scanner’s memory and initializes the scanner to its
default settings.
Resetting the Scanner
1. Turn off the scanner, then turn it on again.
2. Insert a pointed object, such as a straightened paper
clip, into the reset hole on the side of the scanner.
Then gently press and release the reset button
inside the opening. The display goes blank, then
information reappears.
20-566.fm Page 50 Thursday, August 5, 1999 8:04 AM