Radio Shack Auvio 40-293 - Manual (Page 6)

3
Mounting the Speaker
1. Remove the grille to expose
the mounting screws.
. Be sure the mounting tabs
are turned in, allowing the
speaker to fit into the hole.
Then insert the speaker into the
mounting hole.
. Use the supplied screws to
tighten the mounting tabs to the
wall or ceiling. Be careful
not to overtighten.
. Replace the grille.
n
Note: When removing the
speaker from the wall or ceiling, loosen the screws
just enough to remove the speaker. This will prevent
loss of the mounting tabs behind your wall.
Specifications
Power handling (RMS/MAX) ..........................40W RMS/80W Max
Impedance ..........................................................................8 ohms
Woofer ................................................................... 5.25 in(13.3cm)
Tweeter ........................................................................ 1 in (2.5cm)
Sensitivity ....................................................... 87+/-3dB @ 1W 1M
Dimensions (W×H×D) .............9 Ч 9 Ч 3.5” (228 Ч 228 Ч 89 mm)
Specifications are subject to change and improvement without notice. Actual
product may vary from the images found in this document.
Mounting tabs