Maintenance – Radio Shack Auvio 40-293 User Manual
Page 5
.
Connect the wire from the red speaker terminal
to the amplifier’s positive (+) terminal, then
connect the wire from the black speaker terminal
to the amplifier’s negative (–) terminal.
n
Notes:
Make sure that line polarities are matched as
stated.
Avoid routing the speaker wire near electrical wires.
Do not nail, staple, or otherwise puncture the
speaker wire.
Before connecting your speaker to an amplifier,
make sure the amplifier and all associated
equipment is turned off.
Make sure the impedance of the amplifier matches
with the speaker (8 ohms).
Use a speaker cable no thinner than 14 gauge
A.W.G. and no longer than 30 ft to avoid signal loss
in the cable.
Maintenance
Keep the amplifier’s volume at the low position
when you first turn it on to avoid damaging the
speaker.
Do not use overrating power, otherwise sound
quality can be destroyed and loudspeaker drivers
can be damaged.
Clean your speaker with a soft cloth to avoid
damaging your loudspeaker.
This speaker is not magnetically shielded. Placing
it near a TV set may magnetize the TV’s screen and
cause viewing issues.