N-Tron 102PC-SE - Manual (Page 32)

(Revised 2010-11-15) 32
Serial to Ethernet Connectivity
Mandatory Configuration Settings
The following items must be configured in order to use the manual dial-in feature :
Disable Auto dial-in globally on all the serial ports.
# set serial auto-dialin disable
Disable Auto dial-in on the serial port s0.
# set serial s0 auto-dial-in disable
The following items must be configured in order to use the auto dial-in feature
:
Enable Auto dial-in globally on all the serial ports.
# set serial auto-dialin enable
Enable Auto dial-in on the serial port s0.
# set serial s0 auto-dial-in enable
Set the Auto dial-in protocol.
# set serial s0 auto-dialin-protocol
Set the Auto dial-in Server IP Address.
# set serial s0 auto-dialin-ipaddress
Set the port to the one which the telnet client will be connected.
# set serial s0 auto-port-port
An ERROR message will display if any of the above details are not configured or not valid.
Optional Configuration Settings
The following details are optional configurations:
Enable/Disable Switching-between-Dial-in and the Command Prompt feature.
# set serial escape-monitor
Set the Escape-Monitor-String to switch between Dial-in and Command Prompt sessions.
# set serial escape-string "+++inet"
Set the Serial Dial-in Trigger mode. Dictates the criterion for establishing a connection. The options provided are on
reception of . Refer the command line configuration section for a detail know how of this
command.
# set serial s0 auto-dialin trig-mode
Enable/Disable the Raw mode globally for all Auto-Dial-in sessions.
# set ip telnet raw-mode
Enable/Disable the Raw mode for Auto-Dial-in session on serial port s0.
# set serial s0 raw-dial-in