Nautilus TREADCLIMBER TC916 - Manual (Page 50)

0
CONSOLE COdES
customizing the treadclimber
®
tc916
You can customize several parameters on the TreadClimber ® TC916 to conform to
your individual requirements, including changing the workout default values and
setting custom parameters such as time limits, changing screen contrast, changing
language, and changing units.
To change the workout default values:
1. Press [Speed: UP], [2], [ENTER]. The console will display “DEFAULTS”.
2. Press [Speed: UP] or [Speed: DOWN] to scan through the default choices.
Select the option you want to change by pressing [ENTER]. Then, use the
[Speed: UP] or [Speed: DOWN] keys to view the choices for the selected
option. Press [ENTER] to accept the choice for that option.
The default options are as follows:
Change default weight:
• Use the numeric keypad or [Speed: UP] or [Speed: DOWN] keys to change
the desired default weight for your facility. Press [ENTER] to accept the new
value.
Change default workout time:
• Use the numeric keypad or [Speed: UP] or [Speed: DOWN] keys to change the
desired default workout time between 10 and 99 minutes. Press [ENTER] to
accept the new value.
Change default age:
• Use the numeric keypad or [Speed: UP] or [Speed: DOWN] keys to change
the desired default age used to calculate target heart rate. Valid age range is
between 10 and 99. Press [ENTER] to accept the new value.
Change default % Target HR:
• Use the numeric keypad or [Speed: UP] or [Speed: DOWN] keys to change the
desired target HR value based on maximum HR. This is used to calculate the
target heart rate value based on the % of maximum HR. Valid target HR % is
between 40 and 90%. Press [ENTER] to accept the new value.
Change default level:
• Use numeric keypad to change between levels 10 - 20.
Change speed:
• Use the numeric keypad or [Speed: UP] or [Speed: DOWN] keys to change the
desired default speed for your facility. Valid speed range is 0.5 mph – 4 mph
(0.8 – 6.4 kph).
console codes overview
there are 4 groups of
console codes as follows:
customization (codes starting
with 2 or 3), machine status
(codes starting with 4),
diagnostic (codes starting
with 6 or 7), and configuration
(codes starting with 8). each
group of codes is defined
below. to access these
console codes and the
options within each group,
follow the instructions for
each section.