Nautilus TREADCLIMBER TC916 - Manual (Page 11)

11 Nautilus® TreadClimber®, Model TC916 Owner’s Manual
NAuTiLuS ® TrEAdCLimBEr ® OPErATiON
TreadClimber
®
Power Plug receptacle
The Commercial Series TreadClimber
® Model TC 916 has one power plug
receptacle located on the front side of the motor pan.
Turning on the Power
The TreadClimber
® exercise machine can be turned on by moving the power
switch located at the front of the machine, to the ON
position.
understanding the display and
Controls
The TreadClimber
® console display is a computerized panel used to operate
the TreadClimber ® exercise machine and see all workout data and operational
status. You should familiarize yourself with the operation of the TreadClimber ®
machine and location of all keys before beginning use.
Limited Access Control/magnetic Safety Stop
Limited-access control lets you restrict TreadClimber
® machine use to
authorized personnel. It also lets you stop the TreadClimber ® machine in an
emergency. The magnetically-activated control is located on the bottom of
the display as shown. The limited-access control is deactivated on machines
shipped from the factory.
magnetic Safety Stop Activation
To activate the limited-access control and restrict access, place the magnetic
safety stop cord supplied with the TreadClimber
® machine in the designated
area located below the display.
The magnet will activate the control. If you remove the key, the TreadClimber ®
treadle belts will stop and the controller will not respond to any key presses.
Accumulated values will remain on the display until you turn off the power, or
press [CLEAR].
The console will display a message, “REPLACE MAGNET” when you remove
the magnetic key from its designated area. You must replace the key or
deactivate the control to start the walk belts.
on/off switch
magnetic safety stop
Power Plug