Panasonic AJ-D92P - Manual (Page 32)

32
Recording
5. Auto back function
6. Preventing erroneous recording
operations
O
During recording, the unit will not respond to the
pressing of any of the function buttons except
STOP and PAUSE/STILL. (This is to prevent the
transfer to another mode during recording.)
O
When the KEY INHIBIT switch is set to ON, all the
function buttons except for the ones set using setup
menu item No. 000 will no longer work.
Under the initial settings, none of the function
buttons except for STOP and EJECT will work.
When ENA has been selected as the setup menu
item No. 000 setting, all the function buttons are
made operable.
In the playback mode, search for the break in
the video recording, and press the STOP
button within 1 to 2 seconds.
1
Press the REC button and PAUSE/STILL button
at the same time.
After the tape is rewound to the break in the video
recording, the tape is further rewound by the auto
back function, and the unit is set to the REC
PAUSE mode.
2
Press the PAUSE/STILL button to start
recording.
When recording is started, the tape begins its
approach, and recording with frame-to-frame
continuity can be conducted.
3
To initiate frame-to-frame continuity after a break
has been searched for in the playback mode
It is recommended that REC be selected as the setup
menu item No. 105 setting to transfer to the recording
mode more quickly.
1 3 2
Press the REC REVIEW button in the REC
PAUSE mode.
The tape is rewound at approximately –1a normal
speed while the REC REVIEW button is held
down.
The tape is rewound for a minimum of 2 or so
seconds and a maximum of 10 or so seconds.
When the REC REVIEW button is released,
playback automatically starts from the point where
the button was released until the REC PAUSE
position, and the REC PAUSE mode is
established.
1
4. REC REVIEW function
This function serves to play back the part of the tape
immediately before the end of the recording to check
whether the recording was executed properly.
When the temporary stop mode has been released
during a REC REVIEW operation, the REC command
is accepted but recording starts after the tape is
rewound to the frame-to-frame continuity point.
1
In order to ensure frame-to-frame continuity, this
function automatically rewinds the tape for
approximately 1 second after REC PAUSE and stops
the tape.
When recording is to be resumed, the tape begins its
approach and after it is completely on-track, recording
is resumed. In this way, continuous recording free
from disruptions can be ensured.