Installation installing this unit, Mounting with velcro fasteners 37, Installing the microphone – Pioneer CD-BTB20 User Manual
Page 37: Installing this unit, Installation, Mounting with velcro fasteners
Important
! Check all connections and systems before
final installation.
! Do not use unauthorized parts. The use of un-
authorized parts may cause malfunctions.
! Consult with your dealer if installation re-
quires drilling of holes or other modifications
of the vehicle.
! Install the unit where it does not get in the dri-
ver
’s way and cannot injure the passenger if
there is a sudden stop, like an emergency
stop.
! When installing this unit, be sure to make suf-
ficient space on its top surface. There is an an-
tenna under the top surface and covering it
may cause trouble to the radio transmission
and reception.
! Depending on the location of this unit, some
noise could be heard during playback of the
songs on Bluetooth audio player. In this situa-
tion, move this unit so as to reduce noise.
! When mounting this unit, make sure none of
the leads are trapped between this unit and
the surrounding metalwork or fittings.
! Do not mount this unit near the heater outlet,
where it would be affected by heat, or near the
doors, where rainwater might splash onto it.
! Before drilling any mounting holes always
check behind where you want to drill the
holes. Do not drill into the gas line, brake line,
electrical wiring or other important parts.
! If this unit installed in the passenger compart-
ment, anchor it securely so it does not break
free while the vehicle is moving, and cause in-
jury or an accident.
! If this unit is installed under a front seat,
make sure it does not obstruct seat move-
ment. Route all leads and cords carefully
around the sliding mechanism so they do not
caught or pinched in the mechanism and
cause a short-circuit.
Installing this unit
Mounting with Velcro fasteners
Thoroughly wipe off the surface before affixing
the Velcro fasteners.
! If the Velcro fasteners (hard) adhere to the
car mat directly, you may install this unit
without using the Velcro fasteners (soft).
% Mount this unit using the Velcro fasten-
ers.
Velcro fastener (hard)
Car mat or chassis
Velcro fastener (soft)
This unit
Installing the microphone
CAUTION
It is extremely dangerous to allow the micro-
phone lead to become wound around the steer-
ing column or gearstick. Be sure to install the
unit in such a way that it will not obstruct driving.
Note
Install the microphone in a position and orienta-
tion that will enable it to pick up the voice of the
person operating the system.
Installation
En
37
English
Section
07