Powerware 9395 UPS and Plus 1 UPS 650825 kVA - Manual (Page 144)

UPS OPERATING INSTRUCTIONS
EATON Powerware ® 9395 UPS (650–825 kVA) Installation and Operation Manual S 164201725 Rev 2 www.powerware.com 7−2
7.1.1 Control Panel
The control panel is used to set up and control the UPS, and to monitor UPS
operation. For a description of the UPS control panel functions, see paragraph 7.2.
7.1.2 Circuit Breaker
Optional circuit breaker (CB1) is used to control the AC input to the UPS rectifier.
NOTE CB1 is supplied with an extension handle to assist in operating the breaker. This handle can not be
installed permanently and must be removed for the front door to close. Self−stick hook and loop fastener
strips are provided tied to the handle for mounting the handle in a convenient location (such as next to the
breaker on the bottom internal safety shield panel) when not in use. Remove the backing from each strip and
attach one strip to the handle and the other strip to any smooth surface.
7.2 Using the Control Panel
The following paragraphs describe the UPS control panel, including controls and
indicators, and how to monitor UPS operation. The control panel (see Figure 7-2) is
located on the front door of the UPS.
3
1
2
PRESS ANY KEY TO CONTINUE
Figure 7-2. UPS Control Panel
The control panel consists of:
S
A liquid crystal display (LCD) (1)
S
A horizontal row of pushbutton switches (2)
S
A vertical column of status indicators (3). See paragraph 7.2.1.
The following paragraphs describe using the UPS control panel to monitor the UPS.
See paragraph 7.3 for use of the operational controls.
When the UPS powers up, the screen displays the Eaton | Powerware logo as shown
in Figure 7-2. To advance to the Main Menu and Mimic screen, press any control
panel pushbutton once.