Panasonic EY6903 - Manual (Page 8)

- 8 -
. ACCESSORIES
Use only bits suitable for size of drill’s chuck.
. APPENDIX
RECOMMENDED SPEED SELECTION
CAUTION:
USE AT LOW SPEED WHEN STRONG FORCE IS NEEDED DURING OPERATION.
(Using at high speed while a strong force is applied may cause a motor breakdown.)
Use the following as a guide to select low or high speed for the job.
EY6903
DRILLING
SCREW
TIGHTENING
MATERIAL/
CONDITION
MORTAR /
BRICK
WOOD /
YELLOW PINE
METAL METAL HOLE SAW
Wood screws
Thickness: 40 mm
(1-37/64") or less
Cold-rolled steel plate (SPC)
Thickness: 1.6 mm (1/16”) or less
HIGH ø 10 mm (3/8") or less Not used
ø 4.5 mm (11/64")
or less
Not used
ø 3.5 mm (9/64")
or less
LOW
ø 10 mm (3/8") or less
(Slow operation)
ø 25 mm (63/64")
or less
ø 13 mm (1/2")
or less
ø 26 mm
(1-1/64") or less
ø 6 mm (15/64")
or less
EY6932
DRILLING
SCREW
TIGHTENING
MATERIAL/
CONDITION MORTAR / BRICK
WOOD /
YELLOW PINE
METAL METAL HOLE SAW
Wood screws
Thickness: 40 mm
(1-37/64") or less
Cold-rolled steel plate (SPC)
Thickness: 1.6 mm (1/16”) or less
HIGH ø 10 mm (3/8") or less Not used
ø 6.5 mm (1/4")
or less
Not used
ø 4 mm (5/32")
or less
LOW
ø 13 mm (1/2") or less
(Slow operation)
ø 36 mm (1-27/64")
or less
ø 13 mm (1/2")
or less
ø 34 mm (1-11/32")
or less
ø 6.8 mm (17/64")
or less