Panasonic DMC-FZ50 - Manual (Page 18)

Preparation
18
VQT0X92
Inserting/Removing
the Battery
• Check that the camera is turned off.
• Close the flash.
1 Slide the release lever in the
direction of arrow and open the
battery door
.
• Always use genuine Panasonic
batteries (CGR-S006A).
2 Insert:
Insert the charged battery until it
clicks.
Remove:
Slide the lock
to remove the
battery.
3 Close the battery door.
Slide the release lever in the
direction of the arrow.
• Remove the battery after use.
• When a fully charged battery has been
inserted for more than 24 hours, the clock
setting is stored (in the camera) for at
least 3 months even if the battery is
removed. (If you insert a battery that is not
sufficiently charged, the length of time that
the clock setting is stored may become
less.) However, the clock setting is
canceled after this length of time. In this
case, set the clock again. (P26)
• Do not remove the card or the battery
while the card is being accessed. The
data may be damaged. (P20)
• Do not remove the battery with the
camera turned on since the settings on
the camera may not be stored properly.
• The supplied battery is designed only
for the camera. Do not use it with any
other equipment.
OPEN CL OSE
OPEN CL OSE OPEN CL OSE