Panasonic NV-HV60 EN - Manual (Page 8)

8
Manual Tuning Procedure
1 Press [MENU] (7) to display the Main menu on the TV
screen.
2 Press [Cursor] (37) ( 34) to select [TUNER PRESET]
then press [OK] (23).
3 Press [Cursor] (37) ( 34) to select [CH] then select the
channel number you want to tune by pressing [Cursor]
(37) (
21).
4 Confirm that [CLEAR] is set to [OFF].
5 Press [Cursor] (37) ( 34) to select [SEARCH] then
press [Cursor] (37) ( 21) to start the Manual Tuning.
• If the desired TV station has not been tuned, press
[Cursor] (37) ( 21) again.
• Press [MENU] (7) and repeat steps 3-5 for each
programme position you want to tune to a station.
6 Press [MENU] (7) three times to exit the On Screen
Display.
Direct Tuning
Follow steps 1 to 3 of Manual Tuning Procedure.
4 Confirm that [CLEAR] is set to [OFF].
5 Press [Cursor] (37) ( 34) select [SEARCH].
6 Press [Numeric] (2) to enter the number of the desired
programme position.
For the 5A and 9A channels, input the following
numbers:
90 for CH-5A, 91 for CH-9A. (Example for NV-HV60GL.)
• For other channels that require tuning, repeat steps 3-6.
7 Press [MENU] (7) twice to exit the On Screen Display.
Fine Tuning Procedure
Follow steps 1 to 3 of Manual Tuning Procedure.
4 Press [Cursor] (37) ( 34) to select [FINE] then press
[Cursor] (37) ( 21) to obtain the best tuning condition.
• Press [OK] (23) to return the tuning to its former state.
5 Press [MENU] (7) to exit the On Screen Display.
Blanking of Unused Programme Positions
Follow steps 1 to 3 of Manual Tuning Procedure.
4 Press [Cursor] (37) ( 34) to select [CLEAR] then
press [Cursor] (37) ( 21) to select [ON].
• Repeat steps 3-4 for other unused programme positions
to skip during the selection of programme positions.
• To cancel the blanking of a programme position select
that programme position then set [CLEAR] to [OFF].
5 Press [MENU] (7) twice to exit the On Screen Display.
CH 2
END: MENU
CH 2 SEARCH 74
END: MENU
SEARCH
CH 2 AFC: OK
FINE : END: MENU
NV-HV60GL_GN.book 8 ページ ２００３年２月３日 月曜日 午後３時３２分