Panasonic CQ-VD7700U - Manual (Page 15)

ENTER
TILT
OPEN
VOLUME MUTE NAVI DISP
CQ-VD7700U
MODE
OPEN / CLOSE
DISC
POWER NAVIGATION
SD CARD
TRACK/ CHANNEL IN-DASH 7" WIDESCREEN COLOR LCD MONITOR TV / DVD / SD RECEIVER
ASPECT
P·MODE ASP
ENTER
TILT
MUTE MODE
ENTER
35
19
E
N
G
L
I
S
H
CQ-VD7700U/VD7500U
34
18
E
N
G
L
I
S
H
CQ-VD7700U/VD7500U
EN T E R
PWR NAVI MODE MENU
CHAPTER
ASPECT
P-MODE
TRACK
NAVIGATION
STOP
TOP MENU
DVD / SD MENU
ST/ MONO
CH1 CH2
RANDOM
RETURN
OSD
RET
RAND
AUDIO ANGLE
REP
SUB
SPACE MUTE
VOL
GRP
DISP 1 2 3
4 5 6
7
A
8
0
9
PAGE
SCAN
PAUSE PLAY
SUBTITLE
REPEAT SCROLL
TITLE / CHAPTER
VOL
CAR AV
PWR
MUTE
MODE
( a page 36)
( a page 38, 42)
( a page 50)
General
( a page 46)
( a page 37)
( a page 37)
( a page 48)
TV
DVD/VCD (Video CD)/CD/MP3
Radio(AM/FM)
VTR1
VTR2
SD-Card (MPEG4/MP3/AAC/JPEG)
* Selectable only when a CD changer is connected.
[MUTE]
[ ] (OPEN/CLOSE)
[MODE] (POWER)
TILT
CQ-VD7700U
OPEN / CLOSE
OPEN / CLOSE
CQ-VD7700U
TILT
[TILT]
[]] [[]
(Adjust)
[VOLUME]
Power
Turn your car's ignition key to ACC or ON position.
ON: press [MODE] (POWER) on the display unit.
Press [PWR] or [MODE] on the remote control.
OFF: press [MODE] (POWER) again for more than
2 seconds on the display unit.
Press [PWR] again or [MODE] again for more
than 2 seconds on the remote control.
Source selection (Mode)
Press [MODE] to change the mode.
[PWR] (Power) [MODE]
[MUTE]
[}] [{] (VOL)
CH-C (CD Changer Control)*
Mode change on the Touch Panel
Touch and then touch a symbol in the .
A B
Volume
[}] (VOLUME) : up
[{] (VOLUME) : down
(on the remote control)
Setting Range:
–82 dB to 0 dB
0 to 40 (step)
default:
–40 dB
18 (step)
(CQ-VD7700U) (CQ-VD7500U)
Note: The sound level for each source is stored in memory.
Mute
MUTE ON: press [MUTE].
MUTE OFF: press [MUTE] again.
Display Open/Close
OPEN : press [ ] (OPEN/CLOSE).
CLOSE : press [ ] (OPEN/CLOSE) again.
(After returning the lateral angle to the
neutral position.)
Notes:
¡
When the display unit is opened or closed, a loud beep
sounds three times.
¡ If the unit stops halfway, press [ ] (OPEN/CLOSE) again
to draw it all the way in.
¡ Opening/closing the display can be done when the power
is off.
Tilt Angle
q
Press and hold [TILT] on the display unit for more
than 2 seconds.
w
Press []] or [[] to adjust. Setup is the same as
from MENU. Refer to “MENU: User Settings” for
details. (
a page 54)
Notes:
¡
Vertical angle (TILT) is saved in the memory, so when the
display unit is drawn out next, it is automatically set at
the angle and in the position adjusted before.
¡ After adjusting its angle, also adjust the brightness to
make it easy for you to watch. (
a page 58)
¡ The car model and installation conditions may impose
some restrictions on the adjustment of the monitor's
angle.
Folding Down the Display
Temporarily
Fold Down: press [TILT] on the display unit.
Raise: press [TILT] again on the display unit.
Note: Even when the unit power is off, you can fold down
the display te
mporarily.
Warning: Do not touch the unit while the display
is moving. Inserting hands, fingers or foreign
objects into the unit can cause injuries and
damage to the unit.
Cautions:
¡
Avoid physical shock to the monitor.
¡ Do not place any object on the display unit, or subject
it to undue force.
¡ Do not move the display forcibly.
¡ The monitor movable range may be limited by the type of
car, a position where the display is mounted, etc.
Remote Control Sensor
Example: DVD VIDEO
A B
Up Down
or
[ ] ] [ [ ]
(adjust)