Panasonic AJ- DCP - Manual (Page 9)

9
Parts and Their Functions
M TAPE/EE switch
This is used to select the signals to be output
during stop, fast forwarding or rewinding.
TAPE : The signals played back from the tape are
output.
EE : The HD SDI signals are output as the video
signals, and the signals selected by setup
menu item No.700 are output as the audio
signals.
While the switch setting is being changed, the
picture and sound may be disturbed.
N COUNTER button
This is used to select what appears on the counter
display. Each time it is pressed, what is to appear
on the display changes in the following sequence:
CTL 5 TC 5 UB 5 r 5 CTL.
CTL: The tape timer (control signal) is displayed.
TC : The time code is displayed.
UB : The user’s bit is displayed.
r
: The remaining tape and total tape length are
displayed in minute increments.
Example: [r30-46]
Remaining tape: 30 minutes; total tape length:
46 minutes
O RESET button
When this is pressed in the CTL mode, the counter
display is set to 0 (reset).
P REC INHIBIT switch
This is used to permit or inhibit recording on the
cassette tape.
ON : Recording on the cassette tape is inhibited.
The REC INHIBIT lamp on the display lights.
OFF: Recording on the cassette tape is permitted
provided that the cassette’s accidental erasure
prevention tab is set to the recording enable
status.
Front panel