Pioneer DVH-P4100UB - Manual (Page 45)

Initial Settings
Adjusting initial settings
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Press SRC/OFF and hold until the unit
turns off.
2 Press MULTI-CONTROL and hold until
the initial setting menu appears in the dis-
play.
3 Turn MULTI-CONTROL to select one of
the initial settings.
FM STEP (FM tuning step)
—AUTO-PI (auto PI
seek)
—AUX1 (auxiliary input1)—AUX2 (aux-
iliary input2)
—MUTE/ATT (sound muting/at-
tenuation)
—VIDEO IN (AV input setting)—
ILLUMI (illumination color)
—SCROLL (ever
scroll)
—TITLE (multi language)—V.OUT (dis-
play connection)
—DIGITALATT (digital at-
tenuation)
—RESET (audio reset)
Use the following instructions to operate each
particular setting.
Notes
! You can also select the function by pressing
FUNCTION on the remote control.
! To return to the previous display, press
DISP/BACK/SCRL.
! To cancel initial settings, press BAND/ESC.
! When V.OUT is set to ON, you cannot switch
to SCROLL and TITLE.
! When the multi-channel processor (DEQ-
P6600) is connected to this unit, you can oper-
ate
DIGITALATT and RESET.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
! The tuning step remains at 50 kHz during
manual tuning.
1 Use MULTI-CONTROL to select FM STEP
in the initial setting menu.
Refer to Adjusting initial settings on this page.
2 Press MULTI-CONTROL to display the
setting mode.
# Press DISP/BACK/SCRL to return to the pre-
vious display.
3 Turn MULTI-CONTROL to select the FM
tuning step.
Turning
MULTI-CONTROL will switch the FM
tuning step between 50 kHz and 100 kHz. The
selected FM tuning step will appear in the dis-
play.
# You can also perform the same operations by
pressing a or b.
4 Press MULTI-CONTROL to determine
the selection.
# Even if the menu has been canceled before
determination, operation is settled.
Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1 Use MULTI-CONTROL to select AUTO-PI
in the initial setting menu.
Refer to Adjusting initial settings on this page.
2 Press MULTI-CONTROL to turn Auto PI
seek on.
# To turn Auto PI seek off, press
MULTI-CONTROL again.
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source on page 49.
Operating this unit
En
45
Section
02
Operating
this
unit