Recording, Recording cds, All-rec – Panasonic RX-EX1 User Manual
Page 17
RQT5671
17
Recording
RANDOM
REC
1
1
ALL
RANDOM
1
SLEEP
PLAY
REC
FADER
RE
PGM
EQ ON
MONO
ST
RANDOM
1
SLEEP
PLAY
FADER
RE
PGM
EQ ON
MONO
ST
ALL -
REC
REC
ALL -REC
1
SLEEP
PLAY
FADER
RE
PGM
EQ ON
MONO
ST
ALL
RANDOM
1
SLEEP
PLAY
FADER
RE
PGM
EQ ON
MONO
ST
REC
REC
1-
REC
1-
Recording CDs
You can record the whole CD (ALL-REC) or a selected
track(1-REC).
ALL-REC
Preparation: Insert a CD (
page 10)
Press [
9
9
9
9
9 TAPE/CD] to switch to CD mode.
Press [CD REC MODE] so “ALL-REC” is dis-
played.
Each time the button is pressed
ALL-REC
1-REC
OFF
The display shows the length of tape needed.
“C-- -- -- --” indicates the tape needed exceeds 100
minutes. You can still record, but some tracks may not
be recorded if the tape isn’t long enough.
Insert a cassette with the side for recording
facing up.
Press [
] to start recording.
The unit rewinds the tape, records 10 seconds of si-
lence, and then starts recording.
To stop recording
Press [ TAPE/CD]. The CD also stops.
If a track is interrupted at the end of the side fac-
ing up
Recording and CD pauses.
To record the track again on the opposite side
1. Press [
0 TAPE], flip the cassette, and insert it.
2. Press [
].
The unit records 10-second of silence, and resumes re-
cording from the beginning of the cut-off track.
To record selected tracks
Program tracks (
steps and on page 12).
Do steps to above.
You cannot use ALL-REC with repeat or random play
(
page 11).
1-REC
Preparation: Insert a CD (
page 10) and a cassette.
Wind the tape to where you want to start recording.
Press [ TAPE/CD] to switch to CD mode.
Press [CD REC MODE] so “1-REC” is displayed.
Press [REW/–/
] or [
/+/FF] to select the
track you want to record.
Press [
] to start recording.
CD play and recording start at the same time.
To stop recording
Press [ TAPE/CD]. The CD also stops.
To record a track in play
Press [CD REC MODE] to display “1-REC”.
Press [
].
Recording starts from the beginning of the track and stops
when the track finishes.
Recording and CD will stop when the tape reaches its end,
even if the track has not finished.
re-ex1(p16-p22)[P]
00.12.28, 4:53 PM
17