Disarming without a 2-way remote – Python 671XP User Manual

Page 19

disarming without a 2-way remote

This feature allows you to disarm the security system without the 2-

way remote should it be lost, damaged, or disabled. In order to dis-

arm the system without a 2-way remote, you must have the vehicle’s

ignition key and know where the Valet

button is located. Be sure

to check with the installer for the location and the number of presses

of the Valet

button required to disarm the system.

To disarm the security system,

turn the ignition to the ON posi-

tion. Press the Valet

button the

preset number of times (one to

five times) within 15 seconds. After five seconds the system will

disarm. If the system does not disarm, you may have waited too long;

turn the ignition Off and On and try again.

Location of Valet

Button_________________________________

Number of Pulses______________________________________

DRW-35

➜

notes: The first press of the remote button, while the
remote is beeping, only clears the alarm page (no com-
mand is sent to the vehicle).

The transceiver transmits immediately upon system trig-
ger and does not allow disarm during the first 6 seconds
after trigger.

The 2-way remote will respond with a number of beeps
and LED flashes according to whether a pinswitch, sen-
sor, activated the alarm (and also if NPC is active).