LSI SYM22801 - Manual (Page 17)

Detailed Installation Procedure 2-3
Step 10. Replace the cabinet cover as described in the user’s manual
for your computer.
Step 11. Make all external SCSI bus connections.
Remember: The SCSI bus requires proper termination, and no duplicate
SCSI IDs.
Step 12. Finally, refer to the PCI SCSI Device Management System
SDMS 4.0 User’s Guide (or the guide for the software that you
will use) to load the driver software for your particular operating
system.
2.2 Detailed Installation Procedure
This section provides step-by-step instructions for installing the
SYM22801 host adapter and connecting it to your SCSI peripherals. If
you are experienced in these tasks, you may prefer to use the preceding
Section 2.1, “Quick Installation Procedure.” If you are not confident that
you can perform the tasks as described here, LSI Logic suggests getting
assistance.
2.2.1 Before You Start
Before you start, look through the task list below to get an overall idea
of the steps to perform.
•
Open your PC cabinet and select an open PCI slot
•
Insert the host adapter
•
Connect your SCSI peripherals
– Internal
– External
•
Terminate the SCSI bus
•
Set the peripheral SCSI IDs
•
Make any configuration changes
•
Close your PC cabinet
•
Install the software