Lucent Technologies 9077 16S User Manual
Sp switch router adapter guide, 4 update 2
                        Table of contents                                                                        
                Document Outline
- About this Guide
 - Introduction to the SP Switch Router Adapter card
- What is the RS/6000 SP Switch Router ?
 - SP Switch Router systems for IBM sites
 - Upgrading system memory
 - Overview of the SP Switch Router Adapter card
 - Inserting a media card into the SP Switch Router
 - SP Switch Router Adapter card LEDs
 - SP Switch Router Adapter card specifications
 - Assigning filters
 - SNMP on the SP Switch Router Adapter card
 
 - Configuring the SP Switch Router Adapter
- Introduction to installation and configuration
 - Installing an SP Switch Router Adapter card
 - Installing the PCMCIA spinning disk
 - Attaching SP Switch Router cables
 - Configuration required on the SP system
 - Step-by-step media card configuration
 - Step 1. Check SNMP in the SP Switch Router system
 - Step 2. Assign IP addresses
 - Step 3. Change profile settings
 - Step 4. Run dev1config to create grdev1.conf
 - Step 5. Reset card to install files
 - Verify SP Switch Router Adapter card from router
 - Bringing the SP Switch Router Adapter card on-line with the SP
 
 - Monitoring and Management Tools
- SP Switch Router command overview
 - SP Switch Router UNIX tools
 - Using the netstat command
 - Obtaining layer 2 and 3 statistics - grstat
 - SP Switch Router Adapter card maint commands
- Preparing to use maint commands
 - Sample maint commands
- Find hardware and software version numbers - maint 2
 - Find transmit (tx) binary version - maint 102
 - Display configuration and status - maint 3
 - maint 4 - display media statistics
 - maint 5 - display switch statistics
 - maint 6 - display combus statistics
 - Filtering commands - maint 50-58, 150-58
 - List the filters per media card - maint 50
 - List where filters are assigned - maint 54
 - Configure UDP packet discards - maint 89 7
 - Display ARP table - maint 189 1
 - Flush the ARP cache - maint 189 10
 - Display switch route table - maint 189 2
 - “Switch route not found”
 
 
 - Checking for hardware problems - grdiag
 - SP Switch Router dumps
 - Data collection utility - grdinfo
 - SP Switch Router logs
 - Burning in media card flash memory
 
 - Part Numbers
 - Log Messages
 - Network Configuration Examples
 - Upgrading Router Software
 - Index
 
