La Crosse Technology WT-5432 - Manual (Page 13)

13
H. Time Alarm
The projection alarm has two separate alarms for time, “ALM1” and “ALM2”.
The alarms have a different sound; “ALM1” increases in volume after 25
seconds, and again after 50 seconds. “ALM2” is a constant volume. The total
duration is 96 seconds for each alarm.
1. Setting the Alarm
a. Press and hold “ALM1” or
“ALM2” for two seconds until the
alarm time is flashing.
b. Press and release “ALM1/HOUR”
to advance the hour and
“ALM2/MIN” to advance the
minute. The time will display “PM”
if set to PM and nothing if set to
AM.
c. The projection alarm will revert to
normal operation when no buttons
are pressed for 15 seconds.
2. Activating/Deactivating the Alarm
a. After entering the alarm-setting mode the alarm is activated (either
ALM1 or ALM2).
b. To toggle between activating and deactivating the alarm press either the
“ALM1” or “ALM2” buttons briefly. “(((1)))” or “(((2)))” will be
displayed to the right of the time display when the alarm is activated.
c. When the snooze bar is pressed the display will scroll through the
alarm 1 and alarm 2 times in the lower left.
3. Turning the Alarm Off (While Sounding)
a. While either alarm is sounding press and release the “SNOOZE” bar to
disable the alarm for the set duration (See Section II. D.). If the
duration is set to “0” the alarm will be disabled for 24 hours.
b. After the “SNOOZE” bar is pressed the lower left will display the time
remaining on the snooze. The “SNOOZE” bar may be pressed at any
time to restart the snooze duration.
c. To disable the alarm for 24 hours press and release any button other
than the “SNOOZE” bar or projection keys.
Alarm 2 activated