Lucent Technologies 03.0.042.2 - Manual (Page 14)

Change Descriptions
12 Release 8, Issue 3.0 (03.0.042.2)
83. The switch reset when an agent exited AUX work mode.
84. Russian incoming toll intrusion on a call over a Russian 3-wire rotary trunk
to a far end BUSY subscriber caused the caller’s station to enter a
non-functional state, requiring a Busy/Release to return it to service. The
Russian incoming toll intrusion attempt is now denied unless the far end
subscriber has actually answered the call, and the caller’s station idles
correctly when the station goes on-hook.
85. Executing a "display-error" command on a large (e.g., 240 members) trunk
group could cause a system reset.
86. The Terminal Self Administration (TSA) feature could cause a system
reset.
87. If call processing tried to access vector translations at the same time that
these translations were being changed from CMS, a system reset could
occur.
88. Technicians could not clear hyperactive alarms by using the
busy/reset/release sequence on DS1 boards. The "reset board" command
now executes Test #129 (Board Restore).
89. When a call redirects to the attendant due to Direct Inward Dialing (DID) No
Answer Timeout, the display showed "a= XXX-XXX-XXXX to OPERATOR
na". The display now shows "a= XXX-XXX-XXXX to called-station-name
na".
90. When a data link was disconnected in a telecommuter phone call, the voice
call was dropped within 10-60 seconds (most often within 10-30 seconds)
following the warning of link disconnection by the endpoint. Now, the voice
call is dropped within 40-120 seconds (usually 60-90 seconds) following
the link disconnection warning.
91. The title "AAR/ AAR Shortcut Dialing" appeared on the custom form, and
has been changed to "AAR/AAR Dialing without FAC" for the same
functionality.
92. Under the following circumstances: an agent A who was observed by a
supervisor received a call and answered, talked with the customer, pushed
the transfer button and dialed an offnet number, then talked with the offnet
number. When the agent A pushed the transfer button after the supervisor
was bridged on, the call was dropped.
93. List occupancy would be very high after layer 2 would go down on a
TN2158 BRI trunk port. This high occupancy could lead to degradation or
loss of switch service.
94. Native mode H.323 IP stations were unable to make outbound calls.