Kathy Ireland Home WLTL23180 - Manual (Page 8)

8
MAINTENANCE AND TROUBLE-SHOOTING
Most problems can be solved by following the simple steps below. If further assistance is needed, call
our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m.
Mountain Time (excluding holidays).
1. SYMPTOM: THE CONSOLE DOES NOT
FUNCTION PROPERLY
a. Replace the two ÒAAÓ batteries in the console
(see assembly step 5 on page 5). In addition,
make sure the reed switch wire is plugged into the
back of the console (see step 3 on page 5).
b. The console, like most electronics, is susceptible
to static electricity build-up, caused by certain
types of clothing or by the operation of the tread-
mill. If the console blanks out or gives incorrect
readings, apply an anti-static spray to the
handrail. Anti-static spray is available where laun-
dry supplies are sold.
2. SYMPTOM: THE WALKING BELT DOES NOT
MOVE SMOOTHLY
a. If the walking
belt is over-
tightened,
performance
may be
reduced and
the walking
belt may be
permanently
damaged.
Using the allen wrench, turn both rear roller
adjustment bolts counterclockwise 1/4 of a turn.
When the tension of the walking belt is correct,
you should be able to lift each side of the walking
belt 2 to 3 inches. Walk on the treadmill for a few
minutes. Repeat until the walking belt is properly
tightened. Be careful to keep the walking belt
centered.
3. SYMPTOM: THE WALKING BELT SLIPS OR IS
OFF-CENTER
a. If the walking
belt has shifted
to the left side,
use the allen
wrench to turn
the left rear
roller adjustment
bolt clockwise,
and the right bolt counterclockwise, 1/4 of a turn
each. Be careful not to overtighten the walking
belt. Walk on the treadmill for a few minutes.
Repeat until the walking belt is centered.
b. If the walking
belt has shifted
to the right
side, use the
allen wrench to
turn the left rear
roller adjustment
bolt counter-
clockwise, and the right bolt clockwise, 1/4 of a
turn each. Be careful not to overtighten the walk-
ing belt. Walk on the treadmill for a few minutes.
Repeat until the walking belt is centered.
c. If the walking
belt slips when
walked on, use
the allen wrench
to turn both rear
roller adjustment
bolts clockwise,
1/4 of a turn.
When the walking belt is correctly tightened, you
should be able to lift each side of the Walking Belt
2 to 3 inches. Walk on the treadmill for a few min-
utes. Repeat until the walking belt is properly tight-
ened. Be careful to keep the walking belt centered.
2"Ð3"
Bolts
Walking Belt