Kathy Ireland Home WLTL23180 - Manual (Page 4)

4
ASSEMBLY
The help of a second person is recommended for assembly. Set the treadmill in a cleared area and remove
all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires
a phillips screwdriver and two adjustable wrenches (not included).
19
6
1
1. Slide the Handrail (6) onto the four welded bolts in the
Base (19) as shown.
Refer to the inset drawing. Attach the Handrail (6) to the
Base (19) with the four Handrail Nuts (16).
2. Lift the front of the Frame (32) and align the holes near
the front of the Frame with one of the three sets of holes
in the Handrail (6). Insert a Long Pin (5) into each side
of the Handrail and the Frame. Make sure that both
Long Pins are at the same level.
Refer to the inset drawing. Insert a Cotter Pin (8) into
the hole in each Long Pin (5). Make sure that the
Cotter Pins are fully inserted into the holes.
2
32
6
5
5
Bolts
19
6
16
5
8
3. Attach the Console Plate (2) to the Handrail (6) with two
of the six Console Screws (3). Feed the Reed Switch
Wire (7) up through the hole in the Console Plate.
Hold the Console (1) near the Console Plate (2). Plug
the Reed Switch Wire (7) into the back of the Console.
Attach the Console to the Console Plate with four
Console Screws (3). Be careful not to pinch the Reed
Switch Wire.
After you have attached the Console (1), insert any
slack in the Reed Switch Wire (7) into the Handrail (6).
3
1
3
3
2
6
3
7
3