Knoll Systems Front Projector 1080p DLP - Manual (Page 20)

19
CONNECTIONS AND SETUP
Using the Adjustment Feet
The height of the projector can be adjusted
using the adjustment feet when the surface
the projector is placed on is uneven or when
the screen is slanted.
The projection of the image can be made
higher by adjusting the projector when it is in a
location lower than the screen.
1 Press the foot releases and lift
the projector to the desired
angle.
2 Remove your hands from the foot
releases. Once the adjustment
feet have locked in position,
place the projector down.
• If the screen is at an angle, the
adjustment feet can be used to adjust
the angle of the image.
Note
• The projector is adjustable up to
approximately 11 degrees from the standard
position.
• When the height of the projector is adjusted,
the image may become distorted
(keystoned), depending on the relative
positions of the projector and the screen.
See page 42 for details on keystone
correction.
Info
• When lowering the projector, be careful not
to get your finger caught in the area
between the adjustment foot and the
projector.
Foot releases
Adjustment feet