Kohler Purist/Purist with Mood Lighting K-1110-CT-0 - Manual (Page 5)

Page 5 Part No V089160-Issue B Apr 05 Kohler Co.
2.3
WHIRLPOOL INSTALLATION
The Purist whirlpool has been designed for
drop-in installation.
Floor should be flat, level and free of any
bumps and protrusions.
Build stud framing as shown in diagrams,
ensuring that the top is level. Whirlpool must
be installed level at all top edges.
Ensure that the stud framing is not interfering
with pump, controller and whirlpool plumb-
ing.
Whirlpool must be supported both on the
rim and on the wooden feet. Do not allow the
whirlpool to be supported by the rim alone.
Do not concrete in place.
Please remember to provide unrestricted access
to the pump to assist with future maintenance.
Access panels should be wide enough to allow
access to motor, controller and adjacent plumb-
ing and should be secured by screws to prevent
unauthorised tampering.
IMPORTANT:
No motor access, no warranty service.
Use template provided to cut aperture for
whirlpool.
2.4
TAPWARE AND DRAIN
INSTALLATION
Install the tapware and drain, connect the
plumbing to the faucets and waste fitting.
Min 80 mm
Silicone sealant
Finished deck (eg. tiles)
Water resistant wall
material
Timber framing or brick
wall
Finished deck (eg. tiles)
Waterproof membrane
Water resistant wall
material
Timber framing or brick
wall
Waterproof membrane
Spa box ledge upstand
Silicone sealant Spa box ledge
upstand
2.0 INSTALLATION. Cond...
IMPORTANT:
Whirlpool height may vary, do not build support
box until product height can be measured