Kyocera TOMO S2410 - Manual (Page 9)

User Guide 9
1 Get Started
Phone Battery
Install the Battery
1. Hold the phone face
down.
2. Find notch directly
below the back cover.
It is square. Using your
thumbnail, lift the
cover to remove.
3. Place the battery in the
battery casing with the
metal contacts facing
toward the top of the
phone. The metal
contacts of the battery
must make contact
with the metal contacts of the battery
casing.
4. Replace the battery
door by lining up the
notches with the
openings at the top and
on each side of the
battery casing.
5. Snap the cover into
place.
Charge the Battery
1. Connect the AC
adapter to the
microUSB jack on the
side of the phone.
2. Plug the adapter into a
wall outlet.
The battery icon in the
upper-right corner of the screen tells you
whether the phone is:
– Charging (the icon is animated)
– Partially charged
– Fully charged
You must have at least a partial charge in the
battery to make or receive calls. You can safely
recharge the battery at any time, even if it has a
partial charge.
Note: Before removing the battery, make sure
the phone is powered off.
82-R6017-2EN.book Page 9 Friday, December 4, 2009 8:13 AM