KTI Networks KF221TX/3 - Manual (Page 11)

7
5. Insert the adapter into the slot and secure the screw (see Figure 3-1).
6. Install the WOL cable, if necessary. Refer to 3.2 for the details.
7. Replace the computer cover and reconnect all previously
connected cables.
Figure 3-1 Inserting the Adapter into the PCI Slot
3.2 Installing Wake on LAN Cable
Follow the steps to install the Wake on LAN cable:
1. Make sure your system motherboard is RWU capable.
2. Make sure WOL function is enabled in the system BIOS.
3. Refer to your system manual for the active level of your
system PME signal. Set the adapter's PME jumper JP1 to
match the system PME signal level as follows: