Sony DAV-LF1 User Manual

Page 21

Getting Star

ted

To change the speaker cables

If you want to use a different speaker cable, you can detach the plug for attachment to another cable.

Detaching

With the catcher facing down, press and hold the plug down against a flat surface and remove the cords
from plug.

Attaching

While pressing the plug down against a flat surface, insert the new speaker cords.
Note that the cord marked with a line should be attached to the minus (-) side of the plug.

Notes

• Be careful not to damage the surface you use (desk, etc.) when attaching/detaching the speaker cords.

• When using the subwoofer cord, note that the two outside black cords or the cords marked with letters are negative.

• If you connect the subwoofer cord incorrectly or turn up the volume in a state of a short circuit, the standby indicator

flashes and the system enters standby mode. In this case, disconnect and then reconnect the AC power cord (mains
lead) from the wall outlet (mains), and then turn the system on.

Tips

• You can use any commercially sold speaker cable of gauge cord AWG #18 - AWG #22.

• Before attaching a new cable, strip off 10 mm of its insulation and twist the bare wires of both cords.

Catcher

(–)
(+)

(–)

(+)
(–)

10 mm

continued