Woodstock W1770 - Manual (Page 19)

-17-
W1770 21" Bandsaw w/Foot Brake
SE
TU
P
Blade.Tracking
The blade tracking is primarily affected by the tilt of the
upper wheel, also known as "center tracking"; and the
alignment of both wheels, also known as "coplanar track-
ing." (For coplanar tracking, refer to the Wheel.Alignment
instructions on .Page.52.)
The wheels on this bandsaw were aligned at the factory,
so center tracking is the only adjustment that needs to be
performed when the saw is new.
To center track the blade, do these steps:
1. DISCONNECT BANDSAW FROM POWER!
2. Make sure the upper and lower blade guides are
adjusted away from the blade (refer to Adjusting.
Blade.Guide.Bearings on Page.23).
3. Move the quick tension lever to the tightened
position ( Figure.18) and turn the blade tension
handwheel ( Figure.17) until the blade tension
matches the mark on the blade tension scale for the
appropriate blade width (refer to Page.22.to tension
the blade).
4. Open the upper wheel cover, then spin the upper
wheel by hand at least three times and watch how
the blade rides on the crown of the wheel through
the tracking window. Refer to Figure 19 for an illus-
tration of this concept.
— If the blade rides in the center of the upper
wheel and is centered on the peak of the
wheel crown, then the bandsaw is already center
tracked properly and no further adjustments are
needed at this time.
— If the blade does not ride in the center of the
upper wheel and is not centered on the peak of
the wheel crown, then continue with the follow-
ing steps.
5. Loosen the lock lever (Figure.18) so that the blade
tracking knob can rotate.
6. Spin the upper wheel with one hand and rotate the
blade tracking knob with the other hand to make the
blade ride in the center of the bandsaw wheel tire.
7. Tighten the lock lever and close the upper wheel
cover. Note: For the best performance from your
saw, regularly maintain proper tracking of the
blade.
NOTICE
Changes. in. the. blade. tension. may.
change.the.blade.tracking.
Blade Centered
on Peak of Crown
Blade
Centered
on Wheel
CENTER TRACKING
Figure.19. Center tracking profiles.
(Side View)
Figure.17. Front blade tensioning controls.
Blade
Tension
Scale
Blade Tension
Handwhel
Figure.18. Rear blade tensioning and
tracking controls.
Tracking Window
Blade Tracking Knob
Blade Tracking Lock Lever
Quick
Release
Tension
Lever
(Engaged)