Sunway NT 2600 - Manual (Page 38)

114
from ICP-Deutschland, (available from your
specialist dealer), which will guarantee
reliable data transfer.
The addresses of the solar inverter must
be input in the solar inverter using the
Sunways NT Monitor software or input
directly with the keys illustrated on
page 107.
Initialising the remote modem
If a remote modem is installed in the solar
inverter, it must be initialised using a PC
and the Sunways NT Monitor software.
· Connect the powered remote modem to
the PC via the COM port. Use the inter-
face cable provided with the modem for
this purpose. Start the Sunways NT
Monitor and set «Acer Modem» under
the «Settings/Remote Modem» menu.
· Click «Perform initialisation» and wait
until the scroll bar has come to an end.
The modem can now be switched off
and connected to the solar inverter via
the RS 232 interface.
· Attention! Do not initialise the local
modem!
· The remote modem is now initialised
so that it automatically accepts a connec-
tion after two rings and connects at
9600 Baud.