Sharp UX-P100 - Manual (Page 34)

Setting Up and Using OpenLCR
32
1
Press once and once.
2
Press once and once.
3
Press
4
Enter a 2-digit number (“01” to “ 29”)
for the number of minutes of the
SHORT TIME setting. (If the number is
less than 10, enter a 0 before the
number.)
5
Enter a 2-digit number for the number
of minutes of the LONG TIME setting.
(The number must be greater than the
SHORT TIME setting and no more than
30.)
•
Note: If the display shows NO
SERVICE, you must first download the
rate data.
6
Press to begin receiving the rate data for the new settings.
•
Your fax calls OpenLCR and receives the data. This lasts one or two
minutes.
•
Note: If you do not press to receive new data, the settings will
revert to their previous state.
FUNCTION
START/MEMORY
START/MEMORY
Display:
The display briefly shows
your selection, then:
The display briefly shows
your selection. If the
settings were changed, it
will then show:
♦
When you change the SHORT TIME and/or LONG TIME setting, the fax
machine will automatically call OpenLCR and receive rate data for the new
times.
START: DOWNLOAD
LONG TIME
SHORT TIME
LCR SETTING
LCR TIME