Sanyo SCP-200 - Manual (Page 20)

Turning Your Phone On and Off
Turning Your Phone On
To turn your phone on:
ᮣ Press .
Once your phone is on, it displays “Looking for service...”which indicates
that your phone is searching for a signal. When your phone finds a
signal, it automatically enters standby mode – the phone’s idle state. At
this point, you are ready to begin making and receiving calls.
If your phone is unable to find a signal after 15 minutes of searching, a
Power Save feature is automatically activated. When a signal is found,
your phone automatically returns to standby mode.
In Power Save mode, your phone searches for a signal periodically
without your intervention. You can also initiate a search for Sprint PCS
Service by pressing any key (when your phone is turned on).
Tip: The Power Save feature helps to conserve your battery power when you are in an
area where there is no signal.
Turning Your Phone Off
To turn your phone off:
ᮣ Press and hold until you see the powering down
animation on the display screen.
Your screen remains blank while your phone is off (unless the battery is
charging).
Section 2A: Your Sprint PCS Phone – The Basics 14