Samsung Digimax i6 - Manual (Page 35)

ŝ34Ş
Sharpness
Continuous shot OSD(On Screen Display) information
ƈ You can adjust the sharpness of the picture you are about to take. You cannot
check the sharpness effect on the LCD monitor before you take a picture,
because this function is applied only when the captured image is stored on the
memory.
- Soft : The edges of the image are softened.
This effect is suitable for editing images
on your PC.
- Normal : The edges of the image are sharp.
This is suitable for printing.
- Vivid : The edges of the image are emphasized.
The edges will appear sharp, but noise
may occur in the recorded image.
ƈ In any mode with the exception of VOICE
RECORDING mode, you can check the recording
status in the LCD monitor.
ƈ Idle mode : If you select the [Save Mode] and the
camera isn't operated during the
specified time(about 30 SEC.), the
camera power will be idle (LCD monitor :
OFF, Camera status lamp : Blinking) automatically.
- To use the camera again, press any of the camera buttons except the power
button.
- If there is no operation during the specified time, the camera power will be
turned off automatically to save battery life. Refer to page 54 for more
information about the auto power off function.
Full OSD Basic OSD LCD Save
ƈ Select the number of pictures in continuous shooting.
- Single : Take one picture only
- Continuous : Images will be taken continuously
until the shutter button is released.
The shooting capacity depends on
the memory.
ſ High resolution and picture quality increases file
saving time, which increases stand-by time.
SHOOTING
Single
Continuous
SHARPNESS
Soft
Normal
Vivid
OSD INFORMATION
Full
Basic
LCD Save