Standard Horizon Ff520 - Manual (Page 8)

Page 10 FF520
2.2 CONNECTING THE GPS CHART PLOTTERS TO THE FF520
CP155C/CP1000C/CP180/CP180i/CPV350 connections to FF520
1. If the power/data cable is plugged into the CP155C/CP1000C/CP180/CP180i/CPV350,
remove it.
2. Route the cable from the FF520 to the GPS Chart Plotters location.
NOTE
You can disconnect the "Tee" cable from the FF520 to make installation easier. Refer to Section 7.
3. Plug in the "Tee" connector into the GPS Chart Plotter DC/Data connector.
4. Plug in the power data cable into the "Tee" connector.
Figure 2.2 - CP155C Connection
Figure 2.2a - CP1000C Connection
GPS antenna for
CP180i
Connector present
ONLY on
CP180
CP180/CP180i
Tee Cable
F 520 F
Figure 2.2b - CP180/CP180i Connection