Standard Horizon Ff520 - Manual (Page 22)

Page 24 FF520
7. Move the ShuttlePoint knob to highlight YES and press [ENTER] to confirm.
8. Press [CLEAR] to exit.
WARNING
Turn Off and after few seconds turn On the Fish Finder in case of failed firmware upload.
3.4 SYSTEM INFORMATION PAGE FOR CP180/CP180i/CPV350
For troubleshooting you maybe asked by a Standard Horizon Product Support Technician
for the software version of Fish Finder.
The following procedure is how to access this information.
1. From the Chart Page, press [MENU] for two times to open the Setup Menu.
2. Move the ShuttlePoint knob to highlight ABOUT... and press [ENT] or move the
ShuttlePoint knob to the right.
3. A window will be shown with the system information on the Fish Finder Library version
and on the Fish Finder module type and version.
4. Press [CLR] to exit.
3.4.0 The System Update menu
The System Update menu allows downloading the Fish Finder firmware into the Fish Finder
device. To select this menu follow the procedure:
1. From the Chart Page, press [MENU] for two times to open the Setup Menu.
2. Move the ShuttlePoint knob to highlight ABOUT... and press [ENT] or move the
ShuttlePoint knob to the right.
3. A window will be shown with the system information.
4. Press [MENU].
5. Move the ShuttlePoint knob to highlight BBFF FIRMWARE SOFTWARE and press
[ENT] or move the ShuttlePoint knob to the right.
6. The current Fish Finder firmware version is shown in the System Update window that
appears on the screen. Insert the C-CARD with the firmware in one of the GPS Chart
Plotter available slots, and the press [ENT] to update.
7. Move the ShuttlePoint knob to highlight YES and press [ENT] to confirm.
8. Press [CLR] to exit.
WARNING
Turn Off and after few seconds turn On the Fish Finder in case of failed firmware upload.