John Deere AC-G4010S User Manual
Page 32
![background image](/manuals/133975/32/background.png)
Warranty
32
Operator’s Manual
GENERAL EMISSIONS WARRANTY COVERAGE
- California Only -
John Deere warrants to the ultimate purchaser and each subsequent purchaser that the SORE (1) has been designed,
built and equipped so as to conform with all applicable regulations; and (2) is free from defects in materials and
workmanship that cause the failure of a warranted part to conform with those regulations as may be applicable to the
terms and conditions stated below.
(a) The warranty period begins on the date the engine is delivered to an ultimate purchaser or first placed into service.
The warranty period is two years.
(b) Subject to certain conditions and exclusions as stated below, the warranty on emissions related parts is as
follows:
(1) Any warranted part that is not scheduled for replacement as required maintenance in your owner’s manual is
warranted for the warranty period stated above. If the part fails during the period of warranty coverage, the
part will be repaired or replaced by John Deere according to subsection (4) below. Any such part repaired or
replaced under warranty will be warranted for the remainder of the period.
(2) Any warranted part that is scheduled only for regular inspection in your owner’s manual is warranted for the
warranty period stated above. Any such part repaired or replaced under warranty will be warranted for the
remaining warranty period.
(3) Any warranted part that is scheduled for replacement as required maintenance in your owner’s manual is
warranted for the period of time before the first scheduled replacement date for that part. If the part fails before
the first scheduled replacement, the part will be repaired or replaced by John Deere according to subsection (4)
below. Any such part repaired or replaced under warranty will be warranted for the remainder of the period
prior to the first scheduled replacement point for the part.
(4) Repair or replacement of any warranted part under the warranty provisions herein must be performed at a
warranty station at no charge to the owner.
(5) Notwithstanding the provisions herein, warranty services or repair will be provided at all of our distribution
centers that are franchised to service the subject engines.
(6) The owner must not be charged for diagnostic labor that leads to the determination that a warranted part is
in fact defective, provided that such diagnostic work is performed at a warranty station.
(7) John Deere is liable for damages to other engine components proximity caused by a failure under warranty of any
warranted part.
(8) Throughout the engine warranty period stated above, John Deere will maintain a supply of warranted parts sufficient
to meet the expected demand for such parts.
(9) Any replacement part may be used in the performance of any warranty maintenance or repairs and must
be provided without charge to the owner. Such use will not reduce the warranty obligations of John Deere.
(10) Add-on or modified parts that are not exempted by the Air Resources Board may not be used. The use of any
non-exempted add-on or modified parts by the ultimate purchaser will be grounds for disallowing a warranty
claims. John Deere will not be liable to warrant failures of warranted parts caused by the use of a non-exempted
add-on or modified part.
(c) WARRANTED PARTS:
The repair or replacement of any warranted part otherwise eligible for warranty coverage may be excluded
from such warranty coverage if John Deere demonstrates that the engine has been abused, neglected, or
improperly maintained, and that such abuse , neglect ,or improper maintenance was the direct cause of the
need for repair or replacement of the part. That notwithstanding, any adjustment of a component that has
a factory installed, and properly operating, adjustment limiting device is still eligible for warranty coverage.
The following emissions warranty parts list are covered.
(1) Fuel Metering System/
(A) Carburetor and internal parts (and/or pressure regulator or fuel injection system)./
(B) Air/fuel ratio feedback and control system, if applicable./
(C) Cold start enrichment system, if applicable./
(D) Regulator assy (gaseous fuel, if applicable)
(2) Air Induction System/
(A) Intake manifold, if applicable/
(B) Air filter.
(3) Ignition System/
(A) Spark plugs. /
(B) Magneto or electronic ignition system. /
(C) Spark advance/retard system, if applicable.
(4) Exhaust manifold, if applicable
(5) Evaporation System /
(A) Fuel line /
(B) Fuel line fittings