Intellinet Network Solutions 524438 User Manual
Page 21

Enable Radio Measurement: When this parameter is enabled, the Cisco
AP can run the radio monitoring through the associated CCX-compliant
clients to continuously monitor the WLAN radio environment and
discover any new APs that are transmitting beacons.
Non-Serving Channel Measurements: The Cisco access point can
perform monitoring measurements through the CCX-compliant clients
on the non-serving channels when this parameter is enabled.
Limit [xxx] milliseconds (0-2000): This setting limits the channel
measurement time. The default value is 250 milliseconds.
Turn off RF: Click to turn off the radio of the adapter; click again to turn
it back on.
WMM
This screen enables you to configure WMM (Wi-Fi Multimedia) and
other QoS settings, such as Power Save and Direct Link Setup.
WMM Enable: Click the check box (then click “Apply”) to enable the WMM
function, which then lets you configure the WMM Power Save and
Direct Link Setup functions.
• WMM – Power Save Enable: Click the check box to enable, then
click “Setting” to further configure the function as “AC_BK,” “AC_BE,”
“AC_VI” or “AC_VO.”
CONFIGURATION
21