Computer setting adjusting the viewing angle – Iiyama Prolite E4835 User Manual

Page 11

ENGLISH

Signal Timing

Change to the desired signal timing listed on page 19: COMPLIANT TIMING.

Windows 95/98/2000/Me/XP Plug & Play

The iiyama LCD monitor complies with DDC1/2B of VESA standard. The Plug & Play function runs
on Windows 95/98/2000/Me/XP by connecting the monitor to DDC1/2B compliant computer with the
Signal Cable supplied.
For installation on Windows 95/98/2000/Me/XP: The monitor Information File for iiyama monitors
may be necessary for your computer and obtained via the Internet, using the address:

http://www.iiyama.com

NOTE

Monitor Drivers are not required in most cases for Macintosh or Unix operating systems.
For further information, please contact your computer dealer first for advice.

For additional information on how to download the driver for your touch screen monitor,

please access the internet site noted above.

NOTE

For optimal viewing it is recommended to look at the full face of
the monitor.

Hold the stand so that the monitor does not topple when you
change the monitor’s angle.

You are able to adjust the monitor’s angle up to 20 degrees
backward. (The indication of 20 degrees: tilted LCD panel
holds for a moment at this point. Tilt the panel gently; using too
much force can easily cause the tilt angle to exceed 20
degrees.)

In order to ensure a healthy and relaxed body position when
using the monitor at visual display workstations, it is
recommended that the adjusted tilt angle should not exceed
10 degrees. Adjust the monitor’s angle to your own preference.

Do not touch the LCD screen when you change the
angle. It may cause damage or break the LCD screen.

Careful attention is required not to catch your fingers
or hands when you change the angle.
Do not tilt the post beyond 20 degrees except when
repacking the monitor in its box.
To do so may cause the monitor to fall over and break.

COMPUTER SETTING

ADJUSTING THE VIEWING ANGLE

BEFORE YOU OPERATE THE MONITOR 6

NOTE