Getting started – iSymphony SP5BT User Manual
Page 6
User Manual
6
SP5BT
GETTING STARTED
1. Fully charge the battery of the headset and docking
base before initial use:
1) Dock the headset into the docking base.
2) Slide the CHARGE switch on the docking base to the right.
3) Connect the charging cable to the charging port on the docking
base.
4) Connect the other end of the charging cable to the AC adapter, car
adapter or the USB port of your PC. Charging is indicated by a red
LED on the docking base.
5) Allow both the headset and docking base to charge completely;
this may take up to 6.5 hours, depending on the power source
you are using. USB charging is slower than using a car or AC
charger. Charging is complete when the charging LED turns off.
. Pair the headset with a Bluetooth-enabled mobile
phone:
1) Ensure the headset is powered off – the headset must be powered
off to enter pairing mode.
2) Ensure the Bluetooth radio on your mobile phone is powered on.
Please refer to the phone user manual for details.
3) Hold the multifunction key on the headset for 5 seconds. A blue
LED flashes rapidly, then changes to flash alternately red and blue.
The headset is ready to pair.
4) Set the mobile phone to search for Bluetooth devices and follow
the instructions on the phone’s screen. Please refer to the phone
user manual for details. You will recognize the iSymphony SP5BT
headset by its Bluetooth name “iSymphony SP5.”
5) Select the iSymphony SP5BT for pairing. When prompted for a
passkey, enter “1234.”
6) Select the newly paired SP5BT for connection. Within a few seconds
connection is complete and a blue LED flashes slowly on the
headset.