InFocus DH 24PD3 - Manual (Page 15)

15
English
(4) Removing dust
Excessive dust in the dust bag will re-
duce dust-collecting efficiency. Remove
dust from the dust bag regularly.
Remove the dust bag from the main
unit, pull out the rail and throw away
the dust and clean. (see Fig. 14).
4. When not using the dust-collecting
adaptor
When removing the dust-collecting
adaptor and the dust bag to use as a
normal rotary hammer, insert the pro-
vided cap in the hose attachment hole.
(see Fig.15) After removing the dust
bag, the air blowing out from the at-
tachment hole is reduced and no air will
blow onto your face.
5. Rotation only
Remove the dust-collecting adaptor as
it cannot be used. Insert the provided
cap in the hose attachment hole.
The rotary hammer can be set to rota-
tion only mode by rotating the change
lever fully clockwise to mark. (Fig. 16)
To drill a wood or metal material using
the separately sold drill chuck and
chuck adaptor, proceed as follows. In-
stalling drill chuck and chuck adaptor
(Fig. 17):
(1) Attach the drill chuck to the chuck
adaptor.
(2) The part of the SDS-plus shank is the
same as the drill bit. Therefore, refer to
the item of “Mounting the drill bit” for
attaching it.
CAUTION:
⅜ Application of force more than necessary will not only reducing drilling effi-
ciency at all, but will deteriorate the tip edge of the drill bit and reduce the
service life of the rotary hammer in addition.
Rail
Fig. 14
Dust bag
Cap
Fig. 16
Dust bag
attachment hole
Change
lever
Hose attachment
hole
Front cap
Grip
Fig. 17
Chuck adaptor
Drill chuck
Part of SDS-plus
shank
Fig. 15
Cap
Hose attachment
hole
Dust bag attachment hole
Push
button