InFocus DH 24PD3 - Manual (Page 12)

12
English
CAUTION:
⅜ The dust cup and dust collector (B) are for exclusive use of concrete drilling
work. Do not use them for wood or metal drilling work.
⅜ Insert dust collector (B) completely into the chuck part of the main unit.
⅜ When turning the rotary hammer on while dust collector (B) is detached from a
concrete surface, dust collector (B) will rotate together with the drill bit. Make
sure to turn on the switch after pressing dust cup on the concrete surface. When
using dust collector (B) attached to a drill bit that has more than 7-15/32" (190
mm) of overall length, dust collector (B) cannot touch the concrete surface and
will rotate. Therefore please use dust collector (B) by attaching to drill bits which
have 6-17/32" (166 mm), 6-19/64" (160 mm) and 4-21/64" (110 mm) overall length.
⅜ Dump particles after every two or three holes when drilling.
⅜ Please replace the drill bit after removing dust collector (B).
8. Selecting the driver bit
Screw heads or bits will be damaged unless a bit appropriate for the screw
diameter is employed to drive in the screws.
9. Confirm the direction of bit rotation
(Fig. 6)
The bit rotates clockwise (viewed from
the rear side) by pushing the R-side of
the push button. The L-side of the push
button is pushed to turn the bit
counterclockwise.
HOW TO USE
CAUTION:
⅜ To prevent accidents, make sure to turn the switch off and disconnect the plug
from the receptacle when the drill pits and other various parts are installed or
removed. The power switch should also be turned off during a work break and
after work.
1. Switch operation
⅜ The rotation speed of the drill bit can be controlled steplessly by varying the
amount that the trigger switch is pulled. Speed is low when the trigger switch is
pulled slightly and increases as the switch is pulled more. To turn the switch
OFF, release the trigger switch to its original position. However, the switch trig-
ger can only be pulled in halfway during reverse and rotates at half the speed of
forward operation.
⅜ Pulling the trigger and pushing the stopper, it keeps the switched-on condition
which is convenient for continuous running. When switching off, the stopper
can be disconnected by pulling the trigger again. The switch stopper is unusable
during reverse.
Fig. 6
Push
button
R
L
L
R
L
R