Intermec PB41 - Manual (Page 10)

10 PB41 Printer Quick Start Guide
802.11b Self-Test Print-out Explanation
Test Item Description
F/W Ver The internal software version (6.46 or greater)
Timeout The seconds between printing and sleep mode
RF Timeout Never
Baud Rate The speed at which the printer receives data
Parity Odd, Even, or None
Data Bits Matches with computer sending data to printer
Handshake The way the printer handles flow control from host
Burn Adj Amount of heat used to print on the thermal paper
Beeper May be turned On or Off
Chrg Beep May be turned On or Off
Batt1 Volt Current voltage of the first battery pack
Batt2 Volt Current voltage of the second battery pack
Printhd Tmp Temperature of the printer head (between 0 and 50
degrees)
Flash/RAM 1 Mb or 4 Mb Flash/1 Mb or 4 Mb RAM
Boot Ver Boot sector firmware
ComCtl Ver Communication Controller Version
802.11b Config Bar code shows MAC address for 802.11b device;
Network Type Ad hoc (opting not to communicate
through an access point but instead communicating
through other ad hoc printers; Station Name is the
specific name for your printer (i.e. serial number);
DHCP (Dynamic Host Configuration Protocol) if
On this is the only way to determine IP address; IP
Ad
=> bar code and human readable IP address also
shows Subnet Mask, Gateway, and Port addresses;
Encryption (open is unsecured, 40-bit or 128-bit
encryption enabled) if enabled then Key Selected;
Key Selected 1-4 equivalent to a password for your
device.
Available Fonts LOC shows whether a font is Resident (R) or
Downloaded (D); CPI shows characters per inch;
DESCRIPTION describes the font; Version and
DATE of font loads; NAMES give the “Easy Print”
name, the Line Printer name, and the hexadecimal
equivalent of that name.